Butane torch basics: how to fill, purge and adjust
Accessory guides4 min readBy Utopia Smoke Shop

Refill a butane torch the right way: let it cool, bleed the tank, fill in short bursts, wait, then adjust the flame. Plus storage and safety basics.
A refillable butane torch has few parts: a fuel tank, a fill valve on the bottom, an igniter and a flame adjuster. Most torch problems (sputtering, a weak flame, a torch that will not light) trace back to how it was filled. This is the routine that keeps one running. Controls vary by model, so read the manual that came with your torch first.
Before you fill
- Let it cool. Give a torch that was just used at least ten minutes. Keep your fingers off the nozzle.
- Ventilate. Fill outdoors or in a room with good airflow. Butane is heavier than air and collects in low spots.
- Clear the area. No flames, sparks, lit cigarettes, pilot lights or hot surfaces nearby.
- Lock it and turn it down. Engage the safety lock if there is one. Turn the flame adjuster to its lowest setting, toward the minus sign.
Purge the tank
Each refill can trap a little air in the tank. Air takes up space that fuel should fill, and it causes sputtering and a weak flame. Purging, also called bleeding, lets it out.
- Hold the torch upside down, with the valve pointing up and away from your face.
- Press the fill valve with a small screwdriver. You will hear a hiss.
- Hold until the hiss stops.
Escaping butane is extremely cold. Keep it off your skin and away from your eyes.
Fill in short bursts
- Keep the torch upside down.
- Check that the can's nozzle fits the valve. Many cans include adapter tips in the cap.
- Hold the can upside down, straight above the valve, and press down firmly. Keep it vertical so liquid butane goes in instead of spraying out the sides.
- Fill in bursts of about three seconds, with a short pause between them.
- Stop when fuel spits back from the valve or the fuel window shows full. Do not overfill.
Wait before lighting
Set the torch upright and wait three to five minutes. The fuel needs to come back up to room temperature, and any butane that escaped onto the torch or your hands needs to evaporate. Lighting right away risks a flare-up.
Adjust the flame
Point the torch away from yourself and anything that can burn. Ignite it on the low setting, then turn the adjuster slowly toward the plus sign until the flame is a steady, sharp blue. A tall, yellow or roaring flame is set too high, so turn it down. If the flame sputters after a fresh fill, purge and fill again.
Why refined butane matters
Butane is sold in grades, often labeled by how many times the fuel has been refined. Less refined fuel carries more impurities. Torch jets and valves have very small openings, and those impurities can build up and clog them. The signs are a weak or uneven flame and misfires. Use the fuel your torch's manufacturer recommends.
Storage and safety
- Store torches and cans at room temperature, away from sun, heaters and stoves. Never leave them in a hot car.
- Keep them out of reach of children, with the safety lock on.
- The nozzle stays hot after the flame is off. Let it cool before you cap or pocket the torch.
- Check the manual for the longest continuous burn time and stay under it.
- Never puncture or burn a butane can, even an empty one.
- If you smell gas or hear a hiss from a torch that is not in use, take it outdoors, away from any flame, and stop using it.
Where to find torches and butane
The torches and lighters collection shows the tabletop torches, ray-gun style torches, pocket lighters and canned butane photographed at Utopia. Ask at the counter which butane suits your torch. Lighting a cigar is a common use for a torch, and how to cut and light a cigar covers the technique.
Utopia Smoke Shop is at 7625 Firestone Blvd in Downey, open every day from 7 AM to 2 AM. Call (562) 390-0580 to check stock.
Keep reading.

Cigar education4 min read
How to cut and light a cigar
Learn the parts of a cigar, the three common cuts, where to cut, how to toast the foot and light it evenly, and how to pace it once it is lit.
Accessory guides4 min read
How to set up a hookah, from base to bowl
Set up a hookah step by step: the parts, the right water level, packing the bowl, foil or a heat management device, lighting coals and cleanup.
Accessory guides4 min read